Controller Technologies Corporation


Enhancements now allow for support of the following:

  • Dodge Sprinter
  • Chrysler Crossfire
  • ST22 - Sebring/Stratus Coupe
  • SuperCard2 - Model Years '96-'97

*Sprinter & Crossfire support requires the use of the Multiplex Cable

Controller Technologies Corporation © All Rights Reserved.

DRB III Emulator Kit 
Contains everything needed to run the standard DRB III Emulator.  
Includes DRB III+ hardware interface, vehicle cable,
USB cable, and software licence.

Supported Protocols:

  • SAE J1850 PWM (FORD)

  • SAE J1850 VPW


  • ISO 15765 (Network Transport Protocol)

  • ISO 11898 (High Speed CAN)

  • ISO 14230 (Keyword2000)

  • ISO 9141/9141-2 (K-Line)

  • Chrysler Collision Detection Bus (CCD)

  • *All hardware interfaces required for J1979 OBD II Diagnostic applications 

This hardware setup comes equipped with the addition of a J2534 HS CAN Pass-Thru interface, making this setup even more advanced than the original DRB III! This addition will allow flash reprogramming of the latest model year Chrysler vehicles and also allows you to interface with our U-Scan OBD II diagnostic application (our generic scan tool software).

*Note that Powertrain flash files are supported though Chyrsler's Tech Authority website and requires a separate subscription.

DRB III Emulator

The Controller Technologies Corporation DRB III Emulator is the exact scan tool software application used in Chrysler, Jeep, and Dodge dealerships to service non-CAN based vehicles from 1998-2007. The DRB III Emulator software application now runs on your personal computer and interfaces with our custom DRB III+ hardware device to enable all the functions of the original Chrysler DRB III Scan Tool and more.  This software package even comes with non-powertrain ECU programming files to enable reflashing everthing from BCMs to sliding door modules.